|
HANTEK DSO-8072E 2CH 70 MHz Scope
Six in one: Oscilloscope/Recorder/DMM/ Spectrum Analyzer/Frequency Counter/Arbitrary Waveform generator. IP-51 rated for dust, drip and shake proof to withstand harsh environments. Large fuse confirms to European Safety Standard. Battery indicator with easy-changed connect points. Selectable 18650 battery box for matching 18650 battery by yourself. Anti-theft lock hole, tripod fixed hole, hang rope, FLASH light that can be used in darkness. Replaceable BNC safety joints, and additional one set of joints. 1GSa/s sample rate, 2M Memory depth, 6000 counts DMM. Large 5.6 inch TFT Color LCD Display; High Resolution(640*480) 749.00 CHF
|
 |
|
|
AKTION 10% - HANTEK DSO-1072E 2CH 70 MHz Scope
5-in-1 Scope - Recorder - DMM - FFT Spectr. analyzer - Freq-Counter - 5.7" Farbdisplay mit 640x480 Bildpunkten.Speichertiefe 1M Single Channel - 512k Dual Channel. DMM with analog bargraph. 645.00 CHF
|
|
|
|
AC/DC Current Clamp CC-65
AC/DC Current Clamp, 20kHz Bandwidth, 1mV/10mA, 65A; It is a transducer which allows your multimeter to measure current data and enable your oscilloscope to measure the current waveforms. Supplied with coil cable with straight banana plug or BNC plug. 142.00 CHF
|
|
|
|
AC/DC Current Clamp CC-650
AC/DC Current Clamp, 400Hz Bandwidth, 1mV/10mA, 650A; It is a transducer which allows your multimeter to measure current data and enable your oscilloscope to measure the current waveforms. AC/DC Current Clamp, 400Hz Bandwidth, 1mV/10mA, 650A 172.00 CHF
|
|
|
|
Auto High Pressure Ignition Probe HT-25
Auto High Pressure Ignition Probe. Auto ignition probe is a kind of inductive capacitance sensor, iit must match with an oscilloscope. Lead length 2.5 meters, the decay of up to 10,000:1. 27.00 CHF
|
|
|
|
Auto Test Leads (HT30A)
It's a special line for assisting auto measurement instruments to test various types of signals. 21.00 CHF
|
|
|
|
20:1 Attenuator (HT201)
20:1 Attenuator 19.00 CHF
|
|
|
|
Large Dolphin Gator Clip (HT18A)
Large Dolphin Gator Clip 16.00 CHF
|
|
|
|
Break out leads
Break out leads. This breakout lead is easy to take voltage readings from numerous sensors in vehicle engine compartment. 17.00 CHF
|
|
|
|
6-way universal break out leads
6-way universal break out leads. The lead is easy to access the existing automotive wiring harness interface, convenient to read all kinds of sensor signal.The lead with 4 kinds of joint size: 0.6mm, 1.5mm, 2.3mm and 2.8 mm. 115.00 CHF
|
|
|
|
Acupuncture Probe Set
Acupuncture Probe Set 12.00 CHF
|
|
|
|
NEW: Coil-on-Plug and Signal Probe
HT25COP coil-on plug and signal probe can catch the ignition waveform of automobile engine easily. 130.00 CHF
|
|
|
|
Coil on plug Extension Cord
Coil on plug Extension Cord. Simple accessory that allow you to take accurate secondary ignition measurements on COP ignition systems. 27.00 CHF
|
|
|
|
BNC to 4mm Adapter
BNC to 4mm Adapter 9.00 CHF
|
|
|
|
BNC to BNC Cable
1m BNC male to BNC male cable; Frequency range: DC ~ 1GHz; Nominal impedance: 50Ohm; Coaxial cable. 8.00 CHF
|
|
|
|
Multimeter Probe (HT19)
The multimeter probes offer a quick and easy solution, where a permanent connection is not required.Length: 131 mm Diameter: 10 mm Contents:1pc X Red Probe, 1pc X Black Probe 15.00 CHF
|
|
|
|
Auto Power Adapter (HT310)
Passt nicht zu HANTEK DSO-1072E - nur zu 1062B 18.00 CHF
|
|
|
|
Battery (Akku fuer 1062B-1202B) Beschr. kann abw.!
Hantek DS1062B und DS1202B Ersatzakku -- Beschriftung kann abweichen - Akku ist Originalteil von HANTEK mit 3-fach Stecker - Art. PL 727076 - 7.4V - 4500mAh Garantie: Akkus haben 6 Monate Garantie 95.00 CHF
|
|
|
|
|
|