TBFL1 - Transient Limiter

TBFL1 Transient Limiter
Overview

The TBFL1 is a combined transient limiter / attenuator / high pass filter, designed to provide optimum protection of spectrum analyzer or measurement receiver inputs when carrying out conducted noise measurements or other measurements where the input levels cannot be predicted with certainty or where accidental overloads may occur.

Pin- and schottky diodes combined with a multi-stage 10dB attenuator result in a device which can withstand a continuous RF input level of up to 5W (37 dBm). A gas discharge tube provides additional protection against high voltage transients. Furthermore, a 9 kHz high pass filter suppresses harmonics of the mains supply voltage.

With a limiting threshold of +11dBm and a flat frequency response from 9 kHz to 600 MHz, the TBFL1 limiter can be used as protective device for the complete range of conducted noise measurements and in many other applications





Specifications

Frequency range: 9 kHz – 600 MHz
Attenuation: 10 dB – 0.5/+1.2 dB in-band (9 kHz to 600 MHz)
Attenuation HP-filter: > 30 dB @ 2kHz
Maximum continuous RF input power: 5W (+37 dBm) in-band
Maximum DC input voltage: ± 20V
Input matching, linear operating range: 9 kHz - 600 MHz < - 16 dB
Output matching, linear operating range: 9 kHz - 600 MHz < - 23 dB
Linear operating range: up to 0 dBm input level, in-band
Limiting threshold: +11 dBm (@ 37dBm input level)
Input connector: N-female
Output connector: N-male
Dimensions: 156 mm x 26 mm x 26mm
Weight: 170 g

Application

general purpose RF transient limiter
transient limiter for conducted noise measurement set up
Datenblatt >>>> Transient Limiter



 

425.00 CHF

Artikel-Nr: TBFL1  

incl. 7.7% MwSt. zzgl. Versand

kurzfristig lieferbar  
 
Anzahl:   St




TBAS1 RF Attenuator Set The TBAS1 RF attenuator set consists of a 3dB, 6dB, 10dB and 20dB attenuator in a beech wood box 135.00 CHF



TBAS2 SMA Attenuator/Termination The TBAS2 RF SMA attenuator/termination set consists of a 3dB, 6dB, 10dB, 15dB, 20dB and 30dB SMA attenuators in a beech wood box 199.00 CHF



TBAS3 - 10W N RF Attenuator Set The TBAS3 RF attenuator set consists of a 3dB, 6dB, 10dB and 20dB attenuator in a beech wood box 199.00 CHF



TBST120/60/60/2 Shielded Tent The TBST-120/60/60/2 is a shielded tent, designed to suppress interference from ambient noise during EMC pre-compliance measurements. With a size of 120 cm x 60 cm x 60 cm, it can accommodate any Tekbox pre-compliance test equipment such as LISNs or TEM-cells 2'975.00 CHF



TBL0550-1 5uH 50A 5uH 50A Line Impedance Stabilisation Network LISN 785.00 CHF



TBHDR1 High Dynamic Range RF Pre-Amplifier The TBHDR1 is a high dynamic range amplifier with a frequency range from 30kHz to 1.5GHz. Its gain is characterized up to 6GHz. The TBHDR1 has a high IP3 and a low noise figure which makes it an ideal alternative pre-amplifier for spectrum analyzers and receivers in EMC test applications. Due to its low noise figure, high IP3 and gain down to the kHz range it also performs very well as amplifier for active loop antennas. 285.00 CHF



TBL5016-2 LISN 50uH CISPR 16 TBL5016-2 50uH Line Impedance Stabilisation Network LISN CISPR 16 1'325.00 CHF



TBLC08- LISN 50uH TEKBOX EMV Zubehör - EMV Precompliance - LISN TBLC08 50uH Line Impedance Stabilisation Network LISN - CISPR 16 985.00 CHF



TBOH01 - LISN 5uH 5uH Line Impedance Stabilisation Network LISN - CISPR 25The TBOH01 5H LISN is a device required to setup conducted noise measurements of DC-powered devices. It is designed to be used for EMC pre-testing in the frequency range of 150kHz to 110 MHz 375.00 CHF




(C) 2021 - Alle Rechte vorbehalten

Diese Seite drucken