TBHDR1 High Dynamic Range RF Pre-Amplifier

TBHDR1 SPECIFICATIONS

Maximum supply voltage: 5.5V
Maximum input power: +10 dBm
Input, Output: 50 Ohm, SMA female
Nominal supply Voltage: 5V, typ. 100mA, Mini-USB-B connector
1dB output compression point @ 100 MHz: +19.2 dBm typical
1dB output compression point @ 500 MHz: +19 dBm typical
1dB output compression point @ 1000 MHz: +18.3 dBm typical
3rd order output intercept point @ 100 MHz: +38dBm
3rd order output intercept point @ 500 MHz: +37dBm
3rd order output intercept point @ 1000 MHz: +33dBm
Reverse isolation S12: -28dB
Input matching: 30kHz-1.5GHz < – 16 dB
Output matching: 30kHz-1.5GHz < – 10 dB
Noise Figure: 2.7 dB

APPLICATION

general purpose gain block
pre-amplifier in applications with low noise and high IP3 requirements
pre-amplifier for spectrum analyzers, especially in EMC pre-compliance test applications
Loop antenna amplifier

Abbildung ähnlich

TBAS1 RF Attenuator Set The TBAS1 RF attenuator set consists of a 3dB, 6dB, 10dB and 20dB attenuator in a beech wood box 135.00 CHF
TBAS2 SMA Attenuator/Termination The TBAS2 RF SMA attenuator/termination set consists of a 3dB, 6dB, 10dB, 15dB, 20dB and 30dB SMA attenuators in a beech wood box 199.00 CHF
TBAS3 - 10W N RF Attenuator Set The TBAS3 RF attenuator set consists of a 3dB, 6dB, 10dB and 20dB attenuator in a beech wood box 199.00 CHF
TBST120/60/60/2 Shielded Tent The TBST-120/60/60/2 is a shielded tent, designed to suppress interference from ambient noise during EMC pre-compliance measurements. With a size of 120 cm x 60 cm x 60 cm, it can accommodate any Tekbox pre-compliance test equipment such as LISNs or TEM-cells 2'975.00 CHF
TBL0550-1 5uH 50A 5uH 50A Line Impedance Stabilisation Network LISN 785.00 CHF
TBHDR1 High Dynamic Range RF Pre-Amplifier The TBHDR1 is a high dynamic range amplifier with a frequency range from 30kHz to 1.5GHz. Its gain is characterized up to 6GHz. The TBHDR1 has a high IP3 and a low noise figure which makes it an ideal alternative pre-amplifier for spectrum analyzers and receivers in EMC test applications. Due to its low noise figure, high IP3 and gain down to the kHz range it also performs very well as amplifier for active loop antennas. 285.00 CHF
TBL5016-2 LISN 50uH CISPR 16 TBL5016-2 50uH Line Impedance Stabilisation Network LISN – CISPR 16 1'325.00 CHF
TBLC08- LISN 50uH TEKBOX EMV Zubehör - EMV Precompliance - LISN TBLC08 50uH Line Impedance Stabilisation Network LISN - CISPR 16 985.00 CHF
TBOH01 - LISN 5uH 5uH Line Impedance Stabilisation Network LISN - CISPR 25The TBOH01 5µH LISN is a device required to setup conducted noise measurements of DC-powered devices. It is designed to be used for EMC pre-testing in the frequency range of 150kHz to 110 MHz 375.00 CHF

Diese Seite drucken