TBL0550-1 5uH 50A

TEKBOX EMV Zubehör - EMV Precompliance - LISN

The TBL0550-1 5µH LISN is a device required to setup conducted noise measurements of DC-powered electronic equipment. It is designed to be used for measurements in the frequency range of 150kHz to 110 MHz according to CISPR 16-1-2, CISPR-25, EN55025, MIL-STD-461F, ISO11452-4 and with limitations DO-160/ED-14G and ISO 7637-2.
The LISN is inserted into the supply line of the DUT (Device Under Test). Conducted noise which is present at the supply terminals of the DUT can be measured at the BNC connector using a spectrum analyzer or a measurement receiver. The source (supply) terminal and the DUT terminal are decoupled by a 5µH inductor.
Two TBL0550-1 in combination with the Tekbox LISN Mate enable separate measurement of common mode and differential mode noise.
The unit comes equipped with a BNC-male to N-male RG232 cable, mating connectors and ground brackets to attach it to a ground plane.





Specifications

Frequency range: 100 kHz – 150 MHz
DC Resistance: < 5 mΩ
Maximum current: 50A continuous, 70 A for 3 minutes
Nominal operating voltage range: 0 – 60V DC;
Component rating: 250V
High current plug/screw terminals – male: Phoenix Contact 1998933, female: Phoenix Contact 1967375
1µF capacitor can be disconnected internally by removing a jumper
Dimensions: 120 mm x 100 mm x 225 mm (270 mm including ground brackets); weight: 1.6 kg
Datenblatt >>>> TBLC0550-1 LISN Manual



Application
EMC pre-compliance testing of conducted noise

Herstellerlink: 50uh-line-impedance-stabilisation-network-lisn-cispr16




Ebenfalls empfehlenswert

 

785.00 CHF

Artikel-Nr: TBL0550-1  

incl. 7.7% MwSt. zzgl. Versand

ca. 10 Arbeitstage Lieferzeit  
 
Anzahl:   St




TBAS1 RF Attenuator Set The TBAS1 RF attenuator set consists of a 3dB, 6dB, 10dB and 20dB attenuator in a beech wood box 135.00 CHF



TBAS2 SMA Attenuator/Termination The TBAS2 RF SMA attenuator/termination set consists of a 3dB, 6dB, 10dB, 15dB, 20dB and 30dB SMA attenuators in a beech wood box 199.00 CHF



TBAS3 - 10W N RF Attenuator Set The TBAS3 RF attenuator set consists of a 3dB, 6dB, 10dB and 20dB attenuator in a beech wood box 199.00 CHF



TBST120/60/60/2 Shielded Tent The TBST-120/60/60/2 is a shielded tent, designed to suppress interference from ambient noise during EMC pre-compliance measurements. With a size of 120 cm x 60 cm x 60 cm, it can accommodate any Tekbox pre-compliance test equipment such as LISNs or TEM-cells 2'975.00 CHF



TBL0550-1 5uH 50A 5uH 50A Line Impedance Stabilisation Network LISN 785.00 CHF



TBHDR1 High Dynamic Range RF Pre-Amplifier The TBHDR1 is a high dynamic range amplifier with a frequency range from 30kHz to 1.5GHz. Its gain is characterized up to 6GHz. The TBHDR1 has a high IP3 and a low noise figure which makes it an ideal alternative pre-amplifier for spectrum analyzers and receivers in EMC test applications. Due to its low noise figure, high IP3 and gain down to the kHz range it also performs very well as amplifier for active loop antennas. 285.00 CHF



TBLC08- LISN 50uH TEKBOX EMV Zubehör - EMV Precompliance - LISN TBLC08 50uH Line Impedance Stabilisation Network LISN - CISPR 16 985.00 CHF



TBOH01 - LISN 5uH 5uH Line Impedance Stabilisation Network LISN - CISPR 25The TBOH01 5ÁH LISN is a device required to setup conducted noise measurements of DC-powered devices. It is designed to be used for EMC pre-testing in the frequency range of 150kHz to 110 MHz 375.00 CHF



TEKBOX EMC Near Field Probes / 40dB Amp The H20, H10, H5 and E5 are magnetic field (H) and electric field (E) probes for radiated emissions EMC pre-compliance measurements. The probes are used in the near field of sources of electromagnetic radiation. 585.00 CHF




(C) 2021 - Alle Rechte vorbehalten

Diese Seite drucken