TBCG1 Radiating Comb Generator

TBCG1 Radiating Comb Generator

The TBCG1 is a radiating comb generator with an internal antenna and a base frequency of 100MHz. It radiates a comb spectrum characterized up to 6GHz. The comb generator is built and characterized to serve as a rough reference for testing radiated noise measurement set ups in anechoic chambers, TEM/GTEM cells, shielded chambers, etc.

It is a portable device, powered by a 9V alkaline cell.



SPECIFICATIONS

Base frequency: 100 MHz
Characterized comb spectrum: 30 MHz – 6 GHz
Tolerance: +/- 2.5 dB
Power supply: 9V PP3 (E-block) alkaline battery
Current consumption: 175 mA
Dimensions: 80 mm x 61 mm x 27 mm
Weight including battery: 76 g

Warning: the TBCG1 radiates across a wide spectrum, significantly exceeding radiating noise limits specified in any CISPR standard. Use it only in a shielded environment to avoid interference with other electronic products

Turn off the device after its use, to prevent battery drainage (ION = 175mA

Ein ausführliches Datenblatt finden Sie hier:

Documentation
tekbox-TBCG1 Comb Generator [4'346 KB]

 

145.00 CHF

Artikel-Nr: TBCG1  

unser Unternehmen ist nicht mehrwertsteuerpflichtig

kurzfristig lieferbar  
 
Anzahl:   St



TBAS1 RF Attenuator Set The TBAS1 RF attenuator set consists of a 3dB, 6dB, 10dB and 20dB attenuator in a beech wood box 135.00 CHF

TBAS2 SMA Attenuator/Termination The TBAS2 RF SMA attenuator/termination set consists of a 3dB, 6dB, 10dB, 15dB, 20dB and 30dB SMA attenuators in a beech wood box 199.00 CHF

TBAS3 - 10W N RF Attenuator Set The TBAS3 RF attenuator set consists of a 3dB, 6dB, 10dB and 20dB attenuator in a beech wood box 199.00 CHF

TBST120/60/60/2 Shielded Tent The TBST-120/60/60/2 is a shielded tent, designed to suppress interference from ambient noise during EMC pre-compliance measurements. With a size of 120 cm x 60 cm x 60 cm, it can accommodate any Tekbox pre-compliance test equipment such as LISNs or TEM-cells 2'975.00 CHF

TBL0550-1 5uH 50A 5uH 50A Line Impedance Stabilisation Network LISN 785.00 CHF

TBHDR1 High Dynamic Range RF Pre-Amplifier The TBHDR1 is a high dynamic range amplifier with a frequency range from 30kHz to 1.5GHz. Its gain is characterized up to 6GHz. The TBHDR1 has a high IP3 and a low noise figure which makes it an ideal alternative pre-amplifier for spectrum analyzers and receivers in EMC test applications. Due to its low noise figure, high IP3 and gain down to the kHz range it also performs very well as amplifier for active loop antennas. 285.00 CHF

TBL5016-2 LISN 50uH CISPR 16 TBL5016-2 50uH Line Impedance Stabilisation Network LISN – CISPR 16 1'325.00 CHF

TBLC08- LISN 50uH TEKBOX EMV Zubehör - EMV Precompliance - LISN TBLC08 50uH Line Impedance Stabilisation Network LISN - CISPR 16 985.00 CHF

TBOH01 - LISN 5uH 5uH Line Impedance Stabilisation Network LISN - CISPR 25The TBOH01 5µH LISN is a device required to setup conducted noise measurements of DC-powered devices. It is designed to be used for EMC pre-testing in the frequency range of 150kHz to 110 MHz 375.00 CHF

TEKBOX EMC Near Field Probes / 40dB Amp The H20, H10, H5 and E5 are magnetic field (H) and electric field (E) probes for radiated emissions EMC pre-compliance measurements. The probes are used in the near field of sources of electromagnetic radiation. 585.00 CHF

TEKBOX EMC Near Field Probes / 20dB Amp The H20, H10, H5 and E5 are magnetic field (H) and electric field (E) probes for radiated emissions EMC pre-compliance measurements. The probes are used in the near field of sources of electromagnetic radiation. 495.00 CHF

TEKBOX Wideband Amp / 20dB TBWA2 wideband RF amplifiers are versatile building blocks that can easily be integrated into laboratory setups. With a bandwidth of 2MHz to 6GHz, they are ideal to boost the signals picked up by our EMC near field probes. The TBWA2 wideband amplifiers are available with 20dB or 40dB gain. Specifications 295.00 CHF

TEKBOX Active Load TEKBOX EMV Zubehör - Active Load TBOH02 Self Powered Active Load Overview The TBOH02 is a self powered, precision active load. It does not need a separate supply voltage and operates as low as 2V... 245.00 CHF

TBCP1-200 RF Current Monitoring Probe The TBCP1-200 is a fixed aperture RF current monitoring probe, expanding the Tekbox product range of affordable EMC pre-compliance test equipment. The probe has a 3dB bandwidth of approximately 200 MHz and is characterized and usable over the frequency range from 10kHz to 250 MHz. The aperture of the RF current monitoring probe is 25 mm. Its transfer impedance is > 14 dB Ohm in the range from 100 kHz to 200 MHz. 495.00 CHF