TEKBOX EMC Near Field Probes / 40dB Amp

EMC Nearfield Probes / 40dB amp
TBPS01 EMC near field probe set plus TBWA1/40dB wideband amplifier


The H20, H10, H5 and E5 are magnetic field (H) and electric field (E) probes for radiated emissions EMC pre-compliance measurements. The probes are used in the near field of sources of electromagnetic radiation.
They serve to locate and identify potential sources of interference within the building blocks of electronic assemblies.
The probes act similar as wide bandwidth antennas, picking up radiated emissions from components, PCB traces, housing openings or gaps and from any other parts that could be emitting RF. The probes are usually connected to a spectrum analyzer. Scanning the probe over the surface of a PCB assembly or housing quickly identifies locations which emit electromagnetic radiation. By changing to a probe with smaller size, the origination of the emissions can be further narrowed down.
Additional applications are RF immunity tests by feeding a RF signal into the probe and radiating it into potentially susceptible circuit sections: Furthermore the probes can be used in the field of repair or debugging to track down issues in RF signal chains by contactless measurement of RF signal levels. One more application is non- invasive measurement of RF building blocks such as modulators or oscillators. Frequency, phase noise and spectral components can be measured in conjunction with a low noise preamplifier.
The TBSWA1/20dB and TBSWA1/40db wideband amplifiers are connected between EMC probe and Spectrum Analyzer to increase the dynamic range of the measurements.

Every set includes a SMB to SMA cable (0.7

Datasheet
tekbox-emc-probes-manual-_20141024.pdf [711 KB]

Ein ausführliches Datenblatt finden Sie hier:

Documentation

tekbox-emc-probes-manual-_20141024.pdf [711 KB]

Tekbox Produkt Test ab Minute 27

 

585.00 CHF

Artikel-Nr: TBPS01-WA2/40dB  

incl. 7.7% MwSt. zzgl. Versand

ca. 10 Arbeitstage Lieferzeit  
 
Anzahl:   St



NEW: TBAS1 RF Attenuator Set The TBAS1 RF attenuator set consists of a 3dB, 6dB, 10dB and 20dB attenuator in a beech wood box 135.00 CHF

NEW: TBAS2 SMA Attenuator/Termination The TBAS2 RF SMA attenuator/termination set consists of a 3dB, 6dB, 10dB, 15dB, 20dB and 30dB SMA attenuators in a beech wood box 199.00 CHF

NEW: TBAS3 - 10W N RF Attenuator Set The TBAS3 RF attenuator set consists of a 3dB, 6dB, 10dB and 20dB attenuator in a beech wood box 199.00 CHF

NEW: TBST120/60/60/2 Shielded Tent The TBST-120/60/60/2 is a shielded tent, designed to suppress interference from ambient noise during EMC pre-compliance measurements. With a size of 120 cm x 60 cm x 60 cm, it can accommodate any Tekbox pre-compliance test equipment such as LISNs or TEM-cells 2'975.00 CHF

NEW: TBCP1-150 RF Current Monitoring Probe The TBCP1-150 is a fixed aperture RF current monitoring probe, expanding the Tekbox product range of affordable EMC pre-compliance test equipment. The probe has a 3dB bandwidth of approximately 150 MHz and is characterized and usable over the frequency range from 10kHz to 250 MHz. The aperture of the RF current monitoring probe is 25 mm. Its transfer impedance is > 14 dB Ohm in the range from 100 kHz to 150 MHz. 495.00 CHF

NEW: TBCG1 Radiating Comb Generator TBCG1 Radiating Comb Generator 145.00 CHF

NEW: TBCG2 Comb Generator TBCG2 Comb Generator 145.00 CHF

TBLC08- LISN 50uH TEKBOX EMV Zubehör - EMV Precompliance - LISN TBLC08 50uH Line Impedance Stabilisation Network LISN - CISPR 16 985.00 CHF

TBOH01 - LISN 5uH 5uH Line Impedance Stabilisation Network LISN - CISPR 25The TBOH01 5µH LISN is a device required to setup conducted noise measurements of DC-powered devices. It is designed to be used for EMC pre-testing in the frequency range of 150kHz to 110 MHz 375.00 CHF