Bestseller! HANTEK DSO-1062B 2CH 60 MHz Scope
5.7" Farbdisplay mit 640x480 Bildpunkten.Speichertiefe 1M Single Channel - 512k Dual Channel. DMM with analog bargraph. (HAN-1062B) 549.00 CHF
HANTEK DSO-1202B 2CH 200 MHz Scope
5.7" Farbdisplay mit 640x480 Bildpunkten.Speichertiefe 1M Single Channel - 512k Dual Channel. DMM with analog bargraph. (HAN-1202B) 799.00 CHF
AC/DC Current Clamp CC-65
AC/DC Current Clamp, 20kHz Bandwidth, 1mV/10mA, 65A; It is a transducer which allows your multimeter to measure current data and enable your oscilloscope to measure the current waveforms. Supplied with coil cable with straight banana plug or BNC plug. (HAN-CC-65) 135.00 CHF
AC/DC Current Clamp CC-650
AC/DC Current Clamp, 400Hz Bandwidth, 1mV/10mA, 650A; It is a transducer which allows your multimeter to measure current data and enable your oscilloscope to measure the current waveforms. AC/DC Current Clamp, 400Hz Bandwidth, 1mV/10mA, 650A (HAN-CC-650) 165.00 CHF
Auto High Pressure Ignition Probe
Auto High Pressure Ignition Probe. Auto ignition probe is a kind of inductive capacitance sensor, iit must match with an oscilloscope. Lead length 2.5 meters, the decay of up to 10,000:1. (HAN-HT25) 27.00 CHF
Auto Test Leads (HT30A)
It's a special line for assisting auto measurement instruments to test various types of signals. (HAN-HT30A) 19.00 CHF
20:1 Attenuator (HT201)
20:1 Attenuator (HAN-HT201) 15.00 CHF
Large Dolphin Gator Clip
Large Dolphin Gator Clip (HAN-HT18A) 14.00 CHF
Break out leads
Break out leads. This breakout lead is easy to take voltage readings from numerous sensors in vehicle engine compartment. (HAN-HT301) 17.00 CHF
6-way universal break out leads
6-way universal break out leads. The lead is easy to access the existing automotive wiring harness interface, convenient to read all kinds of sensor signal.The lead with 4 kinds of joint size: 0.6mm, 1.5mm, 2.3mm and 2.8 mm. (HAN-HT306) 115.00 CHF
Acupuncture Probe Set
Acupuncture Probe Set (HAN-HT307) 12.00 CHF
NEW: Coil-on-Plug and Signal Probe
HT25COP coil-on plug and signal probe can catch the ignition waveform of automobile engine easily. (HAN-HT25COP) 130.00 CHF
Coil on plug Extension Cord
Coil on plug Extension Cord. Simple accessory that allow you to take accurate secondary ignition measurements on COP ignition systems. (HAN-HT308) 27.00 CHF
BNC to 4mm Adapter
BNC to 4mm Adapter (HAN-HT311) 9.00 CHF
BNC to BNC Cable
1m BNC male to BNC male cable; Frequency range: DC ~ 1GHz; Nominal impedance: 50Ohm; Coaxial cable. (HAN-HT322) 6.00 CHF
Multimeter Probe (HT19)
The multimeter probes offer a quick and easy solution, where a permanent connection is not required.Length: 131 mm Diameter: 10 mm Contents:1pc X Red Probe, 1pc X Black Probe (HAN-HT19) 12.00 CHF
Auto Power Adapter (HT310)
Power your oscilloscopes and other electronic devices through your vehicle's DC outlet with this power adapter; Compatible with most vehicles; Aluminum and plastic materials for durability; To easily connect oscilloscopes and devices to your vehicle's DC outlet; (HAN-HT310) 18.00 CHF
Battery (Akku fuer 1062B-1202B) Beschr. kann abw.!
Hantek DS1062B und DS1202B Ersatzakku -- Beschriftung kann abweichen - Akku ist Originalteil von HANTEK mit 3-fach Stecker - Art. PL 727076 - 7.4V - 4500mAh Garantie: Akkus haben 6 Monate Garantie (HAN-1062B-Battery) 85.00 CHF